News

Inventra products on show at SAHA 2026

The ACP20 portable climatic rack cabin, the MMS20 modular manual mast system and the SEG14 stabilised gimbal system were shown installed at SAHA 2026.

A rack cabin with its door removed, showing the 19-inch rack fitted with patch panels, a switch, a connector panel and an emergency stop button.

Inventra’s ACP20, MMS20 and SEG14 were shown installed at the SAHA 2026 International Defence and Aerospace Exhibition, held at the Istanbul Expo Center from 5 to 9 May 2026.

The exhibition, organised by SAHA Istanbul, brought together more than 1,700 companies, 263 of them international. The products were shown installed rather than on their own, so that the selection chain could be seen.

What was shown

ACP20 Portable Climatic Rack Cabin. Two ACP20 cabins were on display. One had a side panel removed, leaving the 19-inch rack fit-out and its cabling open to view. The ACP20 provides up to 1,500 W of vapour compression cooling, is heated by 750 W or 1,500 W silicone heater mats and can be fitted with optional EMI shielding.

MMS20 Modular Manual Mast System. In the outdoor display area an MMS20 stood mounted on the bed of a pickup, raised and carrying a payload at its head. The hand-cranked mast needs no external power, and its patented hybrid actuator combines trapezoidal screws with steel ropes. The standard build lifts a 58 kg payload to an extended height of 2,500 mm and is rated for a 120 km/h wind load on a 0.4 m² reference area.

SEG14 Multi Channel (EO-LWIR-LRF) Stabilised Gimbal System. Indoors, a SEG14 sat at the head of a mast on a tracked unmanned ground vehicle (UGV). The gimbal combines a 1920×1080 daylight channel with 30× optical zoom, a 1280×1024 long-wave infrared (LWIR) channel with 3.2× optical zoom and a laser rangefinder (LRF) measuring up to 32 km. It offers 360° continuous pan and ±45° tilt at a nominal rate of 180°/s, weighs 8.0 kg and uses dual-loop stabilisation based on a two-axis inertial measurement unit (IMU) and encoders.

The selection chain

With the sensor, the mast and the vehicle carrying them in one place, the selection chain is visible at a glance. The chain starts with the sensor or payload. The positioner is then chosen for the torque, travel range and pointing accuracy the payload requires, and the mast or carrier for the height to be reached and the wind load. The same chain underpins the Applications pages.

The award at the same exhibition

At the same exhibition, ASELSAN presented Inventra with a plaque in the highest-value exporting company category. The ceremony is covered in Inventra receives ASELSAN award for highest export value.

About Inventra

Inventra Mühendislik A.Ş., founded in 2015, designs, manufactures, integrates and qualifies reconnaissance and surveillance systems at its R&D Centre and its Integration and Test Centre in Ankara. Its product line covers multi-channel stabilised thermal imaging gimbals, single and dual axis positioners, masts, tripods and portable climatic rack cabins.

Media contact: infoinventras3.com

Select a frame to open it at full size.