Engineering & Manufacturing

Every product in the range is designed, manufactured, integrated and qualified across two facilities in Ankara.

Facilities

Production, Integration, Test and Qualification Centre
Ostim, Yenimahalle, Ankara
R&D Centre
Teknopark Ankara, Yenimahalle, Ankara

Technical Capabilities

Mechanical Design and Analysis
- Parametric modelling
- Static and dynamic system design
- Structural analysis
- Thermal analysis
Electromechanical System Design
- Dynamic system modelling
- Motion transmission mechanism design
- Actuator and sensor selection
- Control algorithm and driver system design
Electronics and Embedded Software
- Digital circuit design
- Control systems
- Motor driver systems
- ARM, Intel x86 and PIC architectures
Simulation
- Multi-body dynamics (MBD)
- Hardware-in-the-loop (HIL)
- Rapid virtual prototyping
- Control algorithm verification on the microprocessor
Manufacturing
- 5-axis simultaneous CNC milling
- 4+1 axis CNC turning
- Coating and painting
- Electronics, cabling and integration

Test and Qualification

Systems are designed to MIL-STD-810G environmental conditions. The methods below are the ones applied in house.

Condition	Method
Operating temperature	Method 501.5 Proc. II +60 °C (+85 °C optional) · Method 502.5 Proc. II −22 °C (−30 °C optional)
Storage temperature	Method 501.5 Proc. I +70 °C · Method 502.5 Proc. I −32 °C
Solar load	Method 501.5 Proc. II, operating, +55 °C
Vibration	Method 514.6 Proc. I, Category 4, Figure 514.6C-1
Rain	Method 506.5 Proc. I

Request Quote